*5588
A.Gayibov Street

Baku, Azerbaijan

(+99450) 770-55-88

Mobile Phone:

09:00 - 18:00

Monday - Friday

DOKA H20 BEAM

Doka timber formwork beams are the basis for many Doka formwork systems and have a wide range of uses. Hundreds of thousands of these carefully manufactured beams do sterling service on countless construction sites every day. The H20 top and H20 eco beams are familiar names all over the world, and are the right choice for any application.

High load capacity
achieved by innovative composite technology:

permitted bending moment M = 9.0 kNm
allowed shear force Q = 20.0 kN
rigidity E x I = 640 kNm²
weight = 5.6 kg/lin.m

Save on equipment
thanks to optimized load capacity

up to one-third fewer floor props on timber-beam floor formwork Dokaflex 30 tec
up to 30 percent fewer form-tie points in wall areas Timberbeam formwork FF100 tec and Top 100 tec
50 percent fewer primary beams in the superstructures of fully loaded Load-bearing tower Staxo 40

More repeat uses 

thanks to all-round protection
extra-long lifespan, thanks to the proven 'top' beam-end reinforcement
reduced close-out costs, thanks to the I tec sheet that protects the entire length of the flanges

Composite formwork beam 20
(A) Top-beam-end reinforcement
(B) I single sheet
(C) Beams marked in 50-cm increment-grid
(D) System holes
(E) Notch for chalk line

Timber formwork beam H20 top

Reduced damage at the end of the beam
Effective protection against moisture and UV radiation
since ends are sealed around web.
Fast, safe formwork set-up
with markings on the beam chords


(A) Top-beam-end reinforcement
(B) Web in versions N or P
(C) Beams marked in 50-cm increment-grid
(D) 2 system holes at each beam end
(E) Notch for chalk line
(F) Labeling belt width side; Optional: Customising possible

Timber formwork beam H20 eco

High-quality beam chords
thanks to mechanical stress-grading
Less damage to beam-ends
owing to bevelled flange-ends and beam rivets
Easy to handle


because of its very low weight
(A) End-reinforcement with bevelled beam-ends and extra plastic rivet
(B) Web in versions N or P
(C) Beams marked in 50-cm increment-grid
(D) 2 system holes at each beam end
(E) Labelling belt width side; Optional: Customising possible

About product

Moment (M):   5 kNm
Shear force (Q):  11 kN
Rigidity (E x J): 450 kNm²
Weight:  4.7 kg/lfm (N) | 5.3 kg/lfm (P)

Certificate: EN 13377

 

Hit enter to search or ESC to close

ORDER NOW